Steam boilers (BIO)

    
HU      RU   

| Home | Products | References | Video | Price list | Design | Company | Partners | Contact us

Biomass boilers
         For warm water

  • BIO
    Automated, pellet, wood chips,

  • Farmer
    Automated, pellet,wood chips,
    wood logs, multifuel


  • Automat
    Self-loading, automated,
    pellet, wood chips, multifuel

Steam boilers    

  • Low pressure steam (0,5bar) automated boilers for biomass, pellet, wood chips, multifuel        

Coal boilers

  • Automated brown coal boilers
    For warm water or low pressure steam

Fuel feeder systems


CARBOROBOT BIO Steam manually feed


Type name
Subtype
CARBOROBOT BIO Steam 0,5bar
Steam
115kg/h
145kg/h
175kg/h
205kg/h
260kg/h
435kg/h
Nominal power
80kW
100kW
120kW
140kW
180kW
300kW


Fuel is forwarded onto a rotating grate where it is burnt under automatic control. The boiler operates in a 3 point switched-mode fashion, i.e. it is can work on 50% power too. This is controlled by the hetaing technology with the draft regulator. When the required steam pressure is reached, the fan stops and the output power is rapidly reduced to 5-10% of the nominal value. The fire does not go out even with several hours of waiting, hence there is no need for a re-ignition unit. When the boiler switches back on, the full power is reached within a few minutes. The quoted pellet or coal consumption per hour values refer to continuous operation. When heat output is not required and the boiler stops, the fuel consumption becomes negligible. The fuel consumption is essentially determined by the required energy output. Experience shows, that approximately 2kg coal or pellets correspond to 1 m3 of natural gas energy.

CARBOROBOT BIO Steam main parts


1. Boiler body
2. Ash bin
3. Exhaust fan
4. Steam out (Heat flow)
5. Feed water (Return flow)
6. Inspection hole
7. Control unit
8. Agitator motor
9. Ignition hole
10. Rotating grate
11. Fuel container
12. Flue outlet and regulator
13. Ash cleaning holes
14. Cinder door
15. Water drain screw
16. Drive arm
17. Sealed fuel door
8. Heat exchange door
19. Secondary air inlet
20. Cleaning hole of the multicyclone module
21. Service aperture
22. Grate adjustment bearings
23. Banding arc
24. Compass buffers
25. Draught adjusting flap
26. Multicyclone filter
27. Hopper lining
28. Burn back thermostat
29. Manometer
30. Agitator arms
31. Burn back sensor
32. Level sensor switch
33. Level sensor arm
34. Flue gas thermometer
35 Steam safety valave(0,5bar)
36 Steam lead tube(Prohibitid to close)
37.Electronoc pressure sensor
38.Steam temperature sensor
39 Connection of pressure sensor.(The valve must be all the time open. Only at the test may closed !)
40 Water level sensors
40/a Reserve minimum water level sensor
41 Feed water inlet(alternative)
42 --
43 Hot water outlet(if necessary)
44 Place for water thermometer(in case water regime)
45 --
46 Water level observation glass tube
47 SHW heat exchanger returning tube.
48 Vibrator motor

 

Copyright © 2023 CARBOROBOT
Contact informations     tel/fax:+36-13852-862    info@carborobot.com